val l_conv_lift lcl Trendsetter_VLF_Auto If this is 1 or 2, the L & R/S conveyor will raise and lower to match processor height. If lcl is 1 then the conveyor will LOWER before the plate is pushed off the unload table onto the conveyor, and RAISE before the plate is pushed off the conveyor into the processor. If lcl is 2 then the conveyor will RAISE before the plate is pushed off the unload table onto the conveyor, and LOWER before the plate is pushed off the conveyor into the processor. uint8

1

0 to 2

cfg

..\..\ShowAllErrors.htmFirmware 0 Error Index

..\..\ShowAllCommands.htmFirmware 0 Command Index

..\..\ShowAllNVS.htmFirmware 0 NVS Index

Updated: Wed Jul 16 19:37:50 2008 PST